How to Fix a Burnt Printhead on Your Epson Printer
- By Jee Comendador
- On Apr 28, 2023
- Comment 0
If you're an Epson printer user, you may encounter the dreaded "burnt printhead" error message at some point. This can be a frustrating and costly issue, but it's not the end of the world. In this article, we'll show you how to diagnose and fix a burnt printhead on your Epson printer.
First, it's important to understand what causes a burnt printhead. This typically occurs when ink leaks inside the printer and comes into contact with the printhead, causing a short circuit. When this happens, you may see smoke coming out of your printer, and the printhead may be visibly burnt or damaged.
To diagnose whether your printhead is the cause of the issue, you'll need to check the motherboard and printhead separately. Start by looking for the F1 fuse on the motherboard. If this fuse is intact, move on to checking the transistors and capacitors. If the motherboard appears to be fine, inspect the printhead for burnt marks on the flex cable and pins.
If you determine that the printhead is the cause of the issue, unfortunately, there's not much you can do to fix it. You'll need to replace the printhead with a new one. However, you can reuse the FFC (flexible flat cable) that connects the printhead to the motherboard if it's still in good condition.
To reuse the FFC, start by peeling off the blue tape on the back of the cable. Cut off any burnt parts with scissors, then glue the tape back onto the cable. You can use duct tape as a substitute for the blue tape if needed. Wrap paper around the cable and let it dry before using a file and a razor blade to expose the metal wires. Sand the wires with fine sandpaper to finish.
Finally, install the new printhead and test your printer. If everything is working correctly, you should be good to go.
In conclusion, a burnt printhead on your Epson printer can be a frustrating issue, but it's not the end of the world. By following these steps, you can diagnose and fix the issue without having to replace the entire printer. Just remember to always use caution when working with electronic components and follow all safety precautions.