7-pin Carriage CR Encoder & PW Sensor FFC Cable for Epson EcoTank ET-2750

Sensor FFC Cable for Epson Printers

Compatible with Epson ET-2750 and ET-2760. This cable may also work with other EcoTank printers that share the same pin configuration and length. However, the folding pattern might differ, and you may need to adjust it accordingly. Each cable is designed to withstand over 20 folds at 180 degrees.

Specifications:

• Pins: 7-pin (4-pin + 3-pin)
• Length: 390 mm (approximately 15.3 inches)
• Folding: Originally sourced from ET-2750 or ST-2000 models

Cable Connections:

There are two cables that connect to the printhead carriage:

1. Printhead Cable (Not Included):

   • A wide 20-pin cable that connects directly to the printhead at the printhead carriage.
   • It splits into two 10-pin sections and later merges again to connect to CN301 on the mainboard.

2. Sensor Cable (This Product):

   • A slimmer 7-pin cable (4-pin + 3-pin).
   • Starts at CN303 on the mainboard (see diagram below).
   • Splits into two sections at the printhead carriage:
     • 4-pin section – Connects to the CR Encoder at the back of the carriage.
     • 3-pin section – Routes underneath the carriage to the PW Sensor.

Important Note:
Some printers may only use a 4-pin cable, omitting the PW sensor. If your printer falls into this category, you can either purchase our 4-pin cable or trim this 7-pin cable with scissors to create the necessary split.