7-pin Carriage CR Encoder & PW Sensor FFC Cable for Epson EcoTank ET-2750

Availability:
In-Stock
This is the Sensor FFC Cable For Epson ET-2750, ET-2760. You can use it for other EcoTank printers that use same pin configuration and length. However, their folding may be...

$7.99

Title

This is the Sensor FFC Cable

For Epson ET-2750, ET-2760. You can use it for other EcoTank printers that use same pin configuration and length. However, their folding may be different and you may need to fold it in a different way. Each cable should stand 20+ 180-degree foldings.

  • Pin: 7-pin:  4 pin + 3 pin
  • Length: 390 mm, about 15.3 inches
  • Folding: the cable is taken from ET-2750 or ST-2000

Two cables are connected to the printhead carriage:

  1. Printhead Cable: This is a broad 20-pin cable that plugs into the printhead at the printhead carriage. It then bifurcates into two 10-pin separate cables, which subsequently converge again to connect to the CN301 on the mainboard.

  2. Sensor Cable (this product): This is a slimmer cable consisting of a combined 4-pin and 3-pin configuration. It begins as a 7-pin connection at the CN303 (refer to the picture below) on the mainboard. When it reaches the printhead carriage, it separates into two cables. The 4-pin cable goes to the back of the carriage (CR Encoder), and the 3-pin goes underneath the carriage (PW Sensor).