Refilling HP 67 Cartridge with BCH Sponge Refill Kit: A Step-by-Step Guide

Refilling ink cartridges is a cost-effective way to keep your printer running, but it can also be a frustrating experience. One common problem is that the sponge inside the cartridge can fatigue quickly, which can limit the number of pages you can print. To overcome this, you can use a sponge refillable cartridge kit, such as the one from BCH, which allows you to replace the sponges inside the cartridge.

The kit comes with a clear cover for the color and black cartridges, as well as four sponges and a priming syringe. The first step in replacing the sponges is to open the cartridge. This can be a challenging process and requires a sharp blade and a considerable amount of arm strength. Once you've successfully opened the cartridge, you can remove the old sponges and replace them with the new ones from the kit.

It's important to note that the black color is prone to getting glued in place, so make sure you take a mental note of which side is the front and which is the back before you put the black cover back in place. Also, take care not to break the filter that's located underneath the sponges as this can cause the cartridge to fail. To avoid breaking the filter, you can use a rotary tool, or you can use a stove to heat up a screwdriver and use it to pry open the bottom of the cartridge.

Once the sponges are in place, it's time to refill the cartridge with ink. BCH recommends using dye ink, as opposed to pigment ink, which is what the original HP cartridges use. You can purchase a kit with six 100 ml bottles of ink, which should last for about 20 refills. To fill the cartridge, first wash it with distilled water and then squeeze the sponge inside to make it snug inside the cartridge. Finally, replace the cover, making sure to compare it to the original cover to determine which side is up and which is down.

By following these steps, you can extend the life of your printer cartridge and save money on ink. Be sure to check out the video linked above for a step-by-step demonstration of the process.